Block Roller shutter/blind| Block
function block for the control
element Block Roller shutter/blind; the control element must be
connected with this function block. See
Block Presence and Presence
General. The block controls a roller shutter or blind (up/down, height and slat in percent) and contains a shading automation based on the sun position: using the calculated sun position as well as the brightness and temperature inputs, the shading is activated and moved to the stored positions. In addition, a presence simulation is available. |
Inputs |
||
| HE |
Brightness |
Brightness value for the shading automation. |
| TE |
Temperature |
Temperature value for the shading automation. |
| SP |
Lock |
Lock. When the lock is active, the reaction depends on the
parameter „Action on lock“. |
Outputs |
||
| LZ |
Long time |
Long time (drive command up/down). |
| KZ |
Short time |
Short time (step/stop command, slat adjustment). |
| PH |
Height percent |
Target height position in percent. |
| PL |
Slat percent |
Target slat position in percent. |
| SH |
Status height percent |
Feedback of the height position in percent. |
| SL |
Status slat percent |
Feedback of the slat position in percent. |
| ST |
Status |
Status information of the block. Bit 256 is set while
shading is suspended after manual operation. |
| SO |
Sun height (current) |
Currently calculated sun height (for the shading
automation). |
| SW |
Sun angle (current) |
Currently calculated sun angle (azimuth). |
| MR |
Manual time remaining |
Remaining time in minutes while shading is suspended
after manual operation, otherwise 0. Writing 0 to this address from
outside resumes the automatic immediately. See
Shading after manual operation. |
Parameters |
||
| Delay slat |
Delay of the slat setpoint for blind control elements. First the height is sent and only after this time has elapsed the slat. This is necessary for some KNX actuators so that both positions are reached. | |
| Action on lock |
|
|
The shading dialog of the control element sets for how many minutes the automatic is suspended after the blind has been operated by hand. The default is Off, in which case the block behaves as before.